In this post I’m going to unbox and assemble the Creality 3D CR – 10 3D printer which costs approximately $400 with shipping included.
Watch the video review
Where to buy
You can purchase the Creality 3D CR – 10 3D printer on GearBest and it comes with a blue or yellow frame:
Unboxing the 3D printer
Let’s start the unboxing….
The 3D printer was nicely packaged with very thick foam securing the frames and all the components.
The printer comes in a huge box, because it is almost completely assembled. Not only that but the printing volume is 300 x 300 x 400mm. It has the base:
The z axis frame:
The electronics control box:
It even comes with a spatula and painter’s tape to help you remove your prints from the bed.
The kit comes with a one page instruction manual which isn’t really useful.
However, it brings a micro SD card that you can use for your offline prints.
If you connect it to your computer, you can find some PDF files in English with all the instructions to build the printer and prepare the Slicer software with the right settings.
The build process
The assembly couldn’t have been easier, you simply tighten up a few screws and T brackets.
After that step, immediately all your frame is assembled and it feels very sturdy.
The wiring is simple, every wire is braided and labeled, so you know exactly where you should connect each of them.
My prints with Creality 3D CR – 10
Before you start printing, you need to level the bed. I’ve added painter’s tape to the base, turned on the 3D printer, selected Auto Home and disabled the stepper motors.
Then, I’ve started tighten up the bed screws for each corner until I felt the bed was leveled.
In summary It took me about 40 minutes since unboxing until I started my first print. I’ve printed a small test cube with PLA filament.
To be honest I expected that my first print wouldn’t come out right. I thought I might had to adjust some of the Slicer settings or level the bed better. However, the cube was printed perfectly and each face was very smooth.
My second print was a holder for SD cards, micro sd cards and USB drives.I have a lot of SD and micro SD cards that I frequently use with my Raspberry Pi and cameras, so this turned out to be a useful item that I’ll always have on my desk.
Finally, I wanted to 3D print something more challenging and I found this 3d print design for a lamp on thingiverse.
Even though I’ve added the top and bottom parts to Cura to show you, I’ve print them individually.
The bottom came out right and it took about 8 hours to print.
But the top of the lamp holder failed at about 80% of completion due to a bad layer.
Still, the lamp looks really nice and with a great finish.
I didn’t remove the skirt of the prints, because it looked better with it.
I’ve used one RGB lamp that can be remote controlled and has a couple of effects that you can choose from.
Here’s how the lamp looks like after the assembly:
I’m impressed that you can get such good prints so quickly with this printer. I think all the parts fell high quality and the assembly process is clever and easy.
I personally think this is the best printer you can buy within this price range and it’s currently being recommend by the community as the best printer for this price.
If you’re on a $200 budget I still recommend the Tevo Tarantula. However the Creality 3D CR – 10 is a better option if you are willing to spend more, because it will save you a lot of time in the assembly process and bed leveling. The CR-10 will also give you better prints and option to print bigger objects.
You might also like reading: Top 11 Accessories and Supplies for 3D Printers
Thanks for reading!